HEADLIGHT ASSEMBLY(except Sedan) REASSEMBLY

PROCEDURE

INSTALL FRONT TURN SIGNAL LIGHT BULB
1. Install the front turn signal light bulb to the front turn signal light socket.
2. Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow in the illustration to install them as a unit.
INSTALL DISCHARGE HEADLIGHT BULB (for HID Headlight)
1. Set the discharge headlight bulb to the headlight unit.
  
  Note
  
  Do not touch the bulb glass.
2. Lock the set spring to install the discharge headlight bulb as shown in the illustration.
INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY (for HID Headlight)
1. *a Red Line
  
  Turn the socket of the headlight light control ECU sub-assembly in the direction indicated by the arrow in the illustration to attach it.
  Note
  - Check that the O-ring is installed on the headlight light control ECU sub-assembly.
  - Check that the O-ring is not damaged or contaminated with foreign matter. If there is any damage, replace the O-ring with a new one.
  - Do not pull the headlight light control ECU sub-assembly with the socket connected.
2. Check that the red line on the output harness is not twisted and store the harness in the headlight assembly securely so that the output harness is not pinched.
3. *a Lock Mark
  
  Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow in the illustration until the lock marks are aligned to install it.
  Note
  - To prevent incomplete installation, make sure to fully push in and turn the headlight light control ECU sub-assembly until the lock marks are aligned.
  - Do not apply excessive force using a tool.
INSTALL NO. 1 HEADLIGHT BULB (for Halogen Headlight)
1. Turn the No. 1 headlight bulb in the direction indicated by the arrow in the illustration to install it.
  
  Note
  
  Do not touch the bulb glass.
2. Connect the connector.
3. Install the cover.