LIGHTING SYSTEM Hazard Warning Switch Circuit

DESCRIPTION

The combination meter assembly receives the hazard warning signal switch assembly ON signal and controls the operation of the hazard warning lights.

WIRING DIAGRAM


  1. except Sedan

    A01TD3AE24
    *a Hazard Warning Signal Switch Assembly
    *b Combination Meter Assembly

  2. for Sedan

    A01TD3AE25
    *a Hazard Warning Signal Switch Assembly
    *b Combination Meter Assembly

PROCEDURE


  1. READ VALUE USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Data List.

    5. Perform the Active Test according to the display on the GTS.


      Body Electrical > Combination Meter > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Hazard Flasher Switch Hazard warning signal switch signal ON or OFF

      ON: Hazard warning signal switch on

      OFF: Hazard warning signal switch off

      		 -

      Body Electrical > Combination Meter > Data List
      Tester Display
      Hazard Flasher Switch
      OK
      Normal conditions listed above are displayed.
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    1. Remove the hazard warning signal switch assembly.

      Click here

    2. A01TAX7C36
      *a

      Component without harness connected

      (Hazard Warning Signal Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      4 - 1 Hazard warning signal switch on Below 1 Ω
      Hazard warning signal switch off 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (HAZARD WARNING SIGNAL SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY AND BODY GROUND)


    1. Disconnect the E45 combination meter assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      except Sedan
      Tester Connection Condition Specified Condition
      E121-4 - E45-3 (HAZ) Always Below 1 Ω
      E121-4 - Body ground Always 10 kΩ or higher
      E121-1 - Body ground Always Below 1 Ω
      for Sedan
      Tester Connection Condition Specified Condition
      E41-4 - E45-3 (HAZ) Always Below 1 Ω
      E41-4 - Body ground Always 10 kΩ or higher
      E41-1 - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE COMBINATION METER ASSEMBLY for Hatchback, Wagon: Click here
    REPLACE COMBINATION METER ASSEMBLY for Sedan: Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR