PRECAUTION FOR DISCONNECTING THE BATTERY CABLE
Note
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
| System | See Procedure |
|---|---|
| Stop and Start System | |
| Simple Intelligent Parking Assist System | |
| Power Door Lock Control System (for Hatchback, Wagon) |
EXPRESSIONS OF IGNITION SWITCH
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Switch Type | |
|---|---|---|
| Ignition Switch (Position) | Engine Switch (Condition) | |
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |
PRECAUTION FOR HEADLIGHT BULB REPLACEMENT
If even a thin film of oil is left on the surface of a halogen bulb, its service life will be shortened because the light will burn at a higher temperature. When replacing a bulb, be sure to hold the flanged part of the light so that your hand does not contact the glass part of the bulb.
Always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.
Always replace a bulb with another bulb of the same wattage.
If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.
Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may be filled with water through gaps around the socket if it is not installed securely.