WIPER AND WASHER SYSTEM IG Power Source Circuit

DESCRIPTION

This circuit provides power to the headlight cleaner control relay.

WIRING DIAGRAM

A012M8EE02

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - IG CIRCUIT AND BODY GROUND)


    1. Disconnect the A94 headlight cleaner control relay connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      A94-3 (IG) - Body ground Ignition switch ON 11 to 14 V

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A94-4 (E) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR