HEATER ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL HEATER AND ACCESSORY ASSEMBLY


    1. B0042LTC01

      Install the heater and accessory assembly with the 3 nuts.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

      Tech Tips

      Tighten the nuts in the order shown in the illustration to install the heater and accessory assembly.

    2. Engage the clamp.

      B0044CQC01
      *a View A *b View B
      *c View C *d Clip installation angle (30°20' to 60°20')
      *e Clip installation angle (75° to 105°) *f Clip installation angle (-6°19' to 24°19')

    3. Connect each hose and engage the 3 clips within the area shown in the illustration.

    4. Connect the connector.

  2. INSTALL NO. 2 HEAT EXCHANGER UNIT GASKET


    1. Install a new No. 2 heat exchanger unit gasket.

  3. INSTALL NO. 1 EXHAUST PIPE SUB-ASSEMBLY


    1. Install the No. 1 exhaust pipe sub-assembly with the 3 nuts.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

      Tech Tips

      Make sure to install the pipe from the vehicle front.

  4. INSTALL AIR DUCT


    1. Install the air duct with the clip.

  5. INSTALL FRONT FLOOR COVER RH


    1. Engage the 3 clips.

    2. Install the front floor cover RH with the bolt and clip.

  6. INSTALL OUTER COWL TOP PANEL

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  7. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  8. INSTALL WATER GUARD PLATE LH

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  9. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here