HEATER FUEL PUMP INSTALLATION

PROCEDURE

1. INSTALL NO. 2 HEATER PROTECTOR PIPE

   
   
   1. 

      *a	Front of the Vehicle
      *b	Slit
      *c	90°

      Install the No. 2 heater protector pipe as shown in the illustration.

      Note

      
      

      • Make sure the slit is facing the rear of the vehicle.

      • Make sure that the slit cannot be seen from the front of the vehicle.

2. INSTALL NO. 1 HEATER PROTECTOR PIPE

   
   
   1. 

      *a	Front of the Vehicle
      *b	Slit
      *c	90°

      Install the No. 1 heater protector pipe as shown in the illustration.

      Note

      
      

      • Make sure the slit is facing the rear of the vehicle.

      • Make sure that the slit cannot be seen from the front of the vehicle.

3. INSTALL HEATER PUMP ASSEMBLY

   
   

   1. Install the heater pump assembly with the nut.

      

      *a

      Marking (Blue)

      *b

      Marking (Orange)

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   2. Align the markings on each hose and pipe as shown in the illustration and connect them with the clips.

   3. Connect the connector.

4. INSTALL OUTER COWL TOP PANEL

   for Sedan: Click here

   for Hatchback, Wagon: Click here

5. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

   for Sedan: Click here

   for Hatchback, Wagon: Click here

6. INSTALL WATER GUARD PLATE LH

   for Sedan: Click here

   for Hatchback, Wagon: Click here

7. INSTALL DIFFERENTIAL PRESSURE SENSOR ASSEMBLY (for 1AD-FTV)

   Click here

8. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

   Click here