ROOM TEMPERATURE SENSOR REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for LHD with Entry and Start System)

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (except Sedan)

   Click here

4. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (except Sedan)

   Click here

5. REMOVE NO. 1 METER HOOD CLUSTER (except Sedan)

   Click here

6. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (except Sedan)

   Click here

7. REMOVE NO. 1 SWITCH HOLE BASE (except Sedan)

   for LHD:

   Click here

   for RHD:

   Click here

8. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (for Sedan)

   Click here

9. REMOVE NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY (for Sedan)

   Click here

10. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (for Sedan)

    Click here

11. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (for Sedan)

    Click here

12. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for Sedan)

    Click here

13. REMOVE NO. 1 SWITCH HOLE BASE (for Sedan)

    for LHD:

    Click here

    for RHD:

    Click here

14. REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR

    
    

    1. 

       Disengage the 2 claws.

    2. 

       Disconnect the connector and aspirator to remove the cooler (room temp. sensor) thermistor.