ROOM TEMPERATURE SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for LHD with Entry and Start System)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

    Click here

  4. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 1 METER HOOD CLUSTER

    Click here

  6. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  7. REMOVE NO. 1 SWITCH HOLE BASE (for LHD)

    Click here

  8. REMOVE NO. 1 SWITCH HOLE BASE (for RHD)

    Click here

  9. REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR


    1. A00YB4V

      Disengage the 2 claws.

    2. A00Y8TA

      Disconnect the connector and aspirator to remove the cooler (room temp. sensor) thermistor.