COMBUSTION TYPE POWER HEATER SYSTEM, Diagnostic DTC:050

DTC Code DTC Name
050 Detection of No Ignition

DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
050 Detection of No Ignition The ECU is locked as a result of 10 successive heater ignition failures.

  • Intake air duct

  • No. 2 exhaust pipe sub-assembly

  • Fuel pump filter

  • Heater pump assembly

  • Heater assembly

CAUTION / NOTICE / HINT

Tech Tips

Clear the DTCs by pressing the memory clear buttons on the DTC tester to unlock the ECU.

PROCEDURE


  1. INSPECT INTAKE AIR DUCT


    1. Inspect the intake air duct.

      Result
      Result Proceed to
      There is no problem with the intake air duct. A
      The intake air duct is clogged, or other problems are found. B

    B

    CLEAN OR REPLACE INTAKE AIR DUCT

    A

  2. INSPECT NO. 2 EXHAUST PIPE SUB-ASSEMBLY


    1. Inspect the No. 2 exhaust pipe sub-assembly.

      Result
      Result Proceed to
      There is no problem with the No. 2 exhaust pipe sub-assembly. A
      The No. 2 exhaust pipe sub-assembly is clogged, or other problems are found. B

    B

    CLEAN OR REPLACE NO. 2 EXHAUST PIPE SUB-ASSEMBLY

    A

  3. INSPECT HEATER PUMP ASSEMBLY


    1. A012GSXC01
      *a

      Component without harness connected

      (Heater Pump Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Always 9 to 12 Ω

    2. Inspect heater pump assembly operation.


      1. Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2, and check the pressure of the hose by hand.

        Note

        This inspection must be done quickly (within 10 seconds) to prevent damage to the heater pump assembly.

        OK
        Pressure is applied to the hose.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE HEATER PUMP ASSEMBLY Click here

    OK

  4. REPLACE FUEL FILTER ASSEMBLY


    1. Replace the fuel filter assembly with a new one and check that the condition returns to normal.

      for 1AD-FTV: Click here

      for 1ND-TV: Click here

      OK
      The heater ignites normally and starts operating.
      Result
      Proceed to
      OK
      NG

    OK

    END

    NG

    REPLACE HEATER ASSEMBLY Click here