REAR SEAT INNER BELT ASSEMBLY(for Sedan) INSPECTION

PROCEDURE


  1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH


    1. A012HT9C02
      *a

      Component without harness connected

      (Rear Seat Inner with Center Belt Assembly LH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Rear center seat belt not fastened Below 1 Ω
      1 - 2 Rear center seat belt fastened 10 kΩ or higher
      3 - 4 Rear LH seat belt not fastened Below 1 Ω
      3 - 4 Rear LH seat belt fastened 10 kΩ or higher

      If the result is not as specified, replace the rear seat inner with center belt assembly LH.