FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  3. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  5. REMOVE REAR DOOR SCUFF PLATE

    Click here

  6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the rear door opening trim weatherstrip.

  7. REMOVE LAP BELT OUTER ANCHOR COVER


    1. A00Y9M5

      Disengage the 3 claws and remove the lap belt outer anchor cover.

  8. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A00Y8YR

      Remove the bolt to disconnect the floor anchor of the front seat outer belt assembly.

  9. REMOVE CENTER PILLAR LOWER GARNISH

    Click here

  10. REMOVE CENTER PILLAR GARNISH ASSEMBLY

    Click here

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A00Y5T1

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A00Y8T1C01
      *a Protective Tape
      *b Locking Button
      *c Release

      Using a screwdriver, pull out the locking button in the direction indicated by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A00Y815

      Remove the 2 bolts and front seat outer belt assembly.

  12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A00Y6Y2

      Remove the 2 bolts.

    2. Disengage the guide to remove the front shoulder belt anchor adjuster assembly.