CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Engage the 2 hooks in the order shown in the illustration to temporarily install the curtain shield airbag assembly.

      A00YAQMN01

      Note


      • When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.

      • Do not twist the curtain shield airbag assembly when installing it.

    4. Install 2 new bolts, 6 new clips, 2 new spacers and engage the 4 clips in the order shown in the illustration to install the curtain shield airbag assembly to the body panel.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
      A00Y533C01
      *1 Pin *2 Clip
      *3 Curtain Shield Airbag Assembly *4 Body Panel
      *5 Spacer - -

    5. Push the 6 pins into the 6 clips.

      Note

      Make sure that the pins of the clips are pushed in firmly.

    6. A00Y97FC01
      *1 Airbag Connector
      *2 Airbag Connector Lock

      Connect the curtain shield airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    7. Push in the airbag connector lock to install the curtain shield airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. INSPECT SRS WARNING LIGHT

    Click here