KNEE AIRBAG ASSEMBLY(for Hatchback, Wagon) INSTALLATION

PROCEDURE

INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
1. Check that the ignition switch is off.
2. Check that the cable is disconnected from the negative (-) battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. *1 Airbag Connector
  
  *2 Airbag Connector Lock
  
  Connect the airbag connector to the lower No. 1 instrument panel airbag assembly.
  
  Note
  
  When connecting any airbag connector, take care not to damage the airbag wire harness.
4. Push in the airbag connector lock to install the airbag connector.
5. Engage the 6 claws and 2 guides to temporarily install the lower No. 1 instrument panel airbag assembly.
6. Install the 4 bolts.
  
  Torque:
  
  10 N*m { 102 kgf*cm, 7 ft.*lbf }
  
  Note
  
  Confirm that the lower No. 1 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

Click here
INSTALL NO. 1 SWITCH HOLE BASE (for LHD)

Click here
INSTALL NO. 1 SWITCH HOLE BASE (for RHD)

Click here
INSTALL NO. 2 SWITCH HOLE BASE (for RHD)

Click here
INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for LHD)

Click here
INSTALL LOWER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)

Click here
INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Click here
INSTALL NO. 1 METER HOOD CLUSTER

Click here
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Click here
INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Click here
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here
PERFORM DIAGNOSTIC SYSTEM CHECK

Click here
INSPECT SRS WARNING LIGHT

Click here

*1	Airbag Connector
*2	Airbag Connector Lock