SPIRAL CABLE(w/o VSC) INSPECTION

PROCEDURE

1. INSPECT SPIRAL CABLE SUB-ASSEMBLY

   Note

   As the spiral cable sub-assembly may break, do not rotate the spiral cable sub-assembly more than the specified amount.

   
   

   1. Remove the spiral cable sub-assembly from the vehicle.

      Click here

   2. Visually check for defects with the spiral cable sub-assembly.

      
      

      1. The defects are as follows:

         
         

         • Scratches

         • Small cracks

         • Dents

         • Chips

         • Cracks or other damage to the connector

           OK
           No defects are found.

         If any defects are found, replace the spiral cable sub-assembly with a new one.

   3. Check the spiral cable sub-assembly.

      

      *A	w/o Steering Pad Switch	*B	w/ Steering Pad Switch
      *a	Component without harness connected (Spiral Cable Sub-assembly)	-	-
      	Interlock	-	-

      Note

      When rotating the spiral cable, make sure to push on the interlock indicated in the illustration to release the interlock mechanism.

      
      

      1. Set the spiral cable sub-assembly to the center position.

         Click here

      2. Measure the resistance between each terminal of the spiral cable sub-assembly according to the table below.

         Standard Resistance
         w/o Steering Pad Switch: Tester Connection Condition Specified Condition E6-9 (HO) - z8-2 (HO) Always 3 Ω or less E7-1 (D+) - z2-2 (D+) Always Below 1 Ω E7-2 (D-) - z2-1 (D-) Always Below 1 Ω
         w/ Steering Pad Switch: Tester Connection Condition Specified Condition E6-1 (CCS) - z4-3 (CCS) Always 3 Ω or less E6-2 (ECC) - z4-4 (ECC) Always 3 Ω or less E6-2 (ECC) - z1-7 (ECC) Always 3 Ω or less E6-3 (EAU) - z1-8 (EAU) Always 3 Ω or less E6-4 (AU3) - z1-9 (AU3) Always 3 Ω or less E6-5 (AU2) - z1-10 (AU2) Always 3 Ω or less E6-6 (AU1) - z1-11 (AU1) Always 3 Ω or less E6-7 (SDN) - z1-12 (SDN) Always 3 Ω or less E6-9 (HO) - z1-1 (HO) Always 3 Ω or less E6-10 (+DP) - z1-2 (+DP) Always 3 Ω or less E6-11 (-DP) - z1-3 (-DP) Always 3 Ω or less E6-12 (ASL) - z1-4 (ASL) Always 3 Ω or less E6-13 (IL+2) - z1-5 (IL+2) Always 3 Ω or less E6-14 (SUP) - z1-6 (SUP) Always 3 Ω or less E7-1 (D+) - z2-2 (D+) Always Below 1 Ω E7-2 (D-) - z2-1 (D-) Always Below 1 Ω

      3. After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise, and measure the resistance as shown in the table below. Then rotate the spiral cable sub-assembly 5 times counterclockwise, and measure the resistance as shown in the table below.

         Standard Resistance
         w/o Steering Pad Switch: Tester Connection Condition Specified Condition E6-9 (HO) - z8-2 (HO) Always 3 Ω or less E7-1 (D+) - z2-2 (D+) Always Below 1 Ω E7-2 (D-) - z2-1 (D-) Always Below 1 Ω
         w/ Steering Pad Switch: Tester Connection Condition Specified Condition E6-1 (CCS) - z4-3 (CCS) Always 3 Ω or less E6-2 (ECC) - z4-4 (ECC) Always 3 Ω or less E6-2 (ECC) - z1-7 (ECC) Always 3 Ω or less E6-3 (EAU) - z1-8 (EAU) Always 3 Ω or less E6-4 (AU3) - z1-9 (AU3) Always 3 Ω or less E6-5 (AU2) - z1-10 (AU2) Always 3 Ω or less E6-6 (AU1) - z1-11 (AU1) Always 3 Ω or less E6-7 (SDN) - z1-12 (SDN) Always 3 Ω or less E6-9 (HO) - z1-1 (HO) Always 3 Ω or less E6-10 (+DP) - z1-2 (+DP) Always 3 Ω or less E6-11 (-DP) - z1-3 (-DP) Always 3 Ω or less E6-12 (ASL) - z1-4 (ASL) Always 3 Ω or less E6-13 (IL+2) - z1-5 (IL+2) Always 3 Ω or less E6-14 (SUP) - z1-6 (SUP) Always 3 Ω or less E7-1 (D+) - z2-2 (D+) Always Below 1 Ω E7-2 (D-) - z2-1 (D-) Always Below 1 Ω

      4. After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise. Then while rotating the spiral cable sub-assembly 5 times counterclockwise, measure the resistance as shown in the table below.

         Standard Resistance
         w/o Steering Pad Switch: Tester Connection Condition Specified Condition E6-9 (HO) - z8-2 (HO) Always 3 Ω or less E7-1 (D+) - z2-2 (D+) Always Below 1 Ω E7-2 (D-) - z2-1 (D-) Always Below 1 Ω
         w/ Steering Pad Switch: Tester Connection Condition Specified Condition E6-1 (CCS) - z4-3 (CCS) Always 3 Ω or less E6-2 (ECC) - z4-4 (ECC) Always 3 Ω or less E6-2 (ECC) - z1-7 (ECC) Always 3 Ω or less E6-3 (EAU) - z1-8 (EAU) Always 3 Ω or less E6-4 (AU3) - z1-9 (AU3) Always 3 Ω or less E6-5 (AU2) - z1-10 (AU2) Always 3 Ω or less E6-6 (AU1) - z1-11 (AU1) Always 3 Ω or less E6-7 (SDN) - z1-12 (SDN) Always 3 Ω or less E6-9 (HO) - z1-1 (HO) Always 3 Ω or less E6-10 (+DP) - z1-2 (+DP) Always 3 Ω or less E6-11 (-DP) - z1-3 (-DP) Always 3 Ω or less E6-12 (ASL) - z1-4 (ASL) Always 3 Ω or less E6-13 (IL+2) - z1-5 (IL+2) Always 3 Ω or less E6-14 (SUP) - z1-6 (SUP) Always 3 Ω or less E7-1 (D+) - z2-2 (D+) Always Below 1 Ω E7-2 (D-) - z2-1 (D-) Always Below 1 Ω

         If the result is not as specified, replace the spiral cable sub-assembly.