SPIRAL CABLE(w/o VSC) REMOVAL

PROCEDURE


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. INSPECT SPIRAL CABLE SUB-ASSEMBLY


    1. B0043S5C01
      *A Flat Cable Type
      *B Colored Roller Type
      *a Flat Cable
      *b Colored Roller

      Check the colored roller or flat cable shown in the illustration.

      If the colored roller or flat cable shown in the illustration cannot be confirmed, it is possible that the spiral cable sub-assembly is broken. Replace the spiral cable sub-assembly with a new one.

  4. REMOVE STEERING COLUMN COVER

    Click here

  5. REMOVE SPIRAL CABLE SUB-ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Check that the front wheels are facing straight ahead.

    4. B0044FTC01
      *1 Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    5. Disconnect the other connectors from the spiral cable sub-assembly.

    6. B0043OD

      Disengage the 3 claws to remove the spiral cable sub-assembly.