COMBINATION METER(for Sedan) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  4. REMOVE NO. 1 INSTRUMENT PANEL REGISTER SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  7. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

    Click here

  8. REMOVE COMBINATION METER ASSEMBLY


    1. A01LZZ8

      Remove the 2 screws.

    2. A01LXCF

      Disengage the 2 clips as shown in the illustration.

    3. Disconnect each connector and remove the combination meter assembly.