PERSONAL LIGHT INSPECTION

PROCEDURE


  1. INSPECT MAP LIGHT ASSEMBLY


    1. A00Y7TGC03
      *A w/ Room Light (for Push Switch Type)
      *a

      Component without harness connected

      (Map Light Assembly)

      Inspect the personal lights.


      1. Apply battery voltage to the each terminal of map light assembly connector and check the operation of the personal lights.

        Result
        Connection Condition Specified Condition

        Battery positive (+) → 8 (+B1)

        Battery negative (-) → 11 (GND)

        		 Personal light switches off and interior light door switch off Personal light LH and RH do not come on
        Personal light switch LH on Personal light LH comes on
        Personal light switch RH on Personal light RH comes on

        Battery positive (+) → 8 (+B1)

        Battery negative (-) → 3 (CTY)

        		 Personal light switches off and interior light door switch off Personal light LH and RH do not come on
        Personal light switches off and interior light door switch DOOR Personal light LH and RH come on

        If the result is not as specified, replace the bulb or map light assembly.

    2. w/ Room Light (for Push Switch Type):


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        7 (RRMP) - 3 (CTY) Interior light door switch off 10 kΩ or higher
        7 (RRMP) - 3 (CTY) Interior light door switch DOOR Below 1 Ω

        If the result is not as specified, replace the map light assembly.