SIMPLE INTELLIGENT PARKING ASSIST SYSTEM TERMINALS OF ECU


  1. CLEARANCE WARNING ECU ASSEMBLY

    A00Y7PGE03

    1. Disconnect the E98 clearance warning ECU assembly connector.

    2. Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      E98-18 (IG) - E98-16 (E)

      L - BR*2

      SB - BR*3

      		 IG power source signal Ignition switch off Below 1 V
      Ignition switch ON

      9.5 to 14 V*2

      11 to 14 V*3
      E98-16 (E) - Body ground BR - Body ground Ground Always Below 1 Ω
      E98-32 (RL) - E98-16 (E)*1 R - BR Back-up light switch assembly signal Ignition switch ON, shift lever in R 11 to 14 V
      Ignition switch ON, shift lever in any position other than R Below 1 V

      If the result is not as specified, there may be a malfunction in the wire harness.


      • *1: for MT or MMT

      • *2: w/ Stop and Start System

      • *3: w/o Stop and Start System

    3. Reconnect the E98 clearance warning ECU assembly connector.

    4. Measure the voltage according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      E98- 31 (R3) - E98-16 (E) W - BR IPA main switch assembly signal Ignition switch ON, IPA main switch assembly pressed Below 1 V
      Ignition switch ON, IPA main switch assembly not pressed 9.5 to 14 V

      If the result is not as specified, the clearance warning ECU assembly may be malfunctioning.