SIMPLE INTELLIGENT PARKING ASSIST SYSTEM Main Switch Circuit

DESCRIPTION

When the IPA main switch assembly is turned on, a signal is sent to the clearance warning ECU assembly. The simple intelligent parking assist system operates according to this signal.

WIRING DIAGRAM

A00YBF5E06

PROCEDURE


  1. INSPECT IPA MAIN SWITCH ASSEMBLY


    1. Remove the IPA main switch assembly.

      Click here

    2. Inspect the IPA main switch assembly.

      Click here

      OK
      IPA main switch assembly is normal.
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE IPA MAIN SWITCH ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (IPA MAIN SWITCH ASSEMBLY - CLEARANCE WARNING ECU ASSEMBLY AND BODY GROUND)


    1. Disconnect the E101 IPA main switch assembly connector.

    2. Disconnect the E98 clearance warning ECU assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E101-6 (IG) - E98-31 (R3) Always Below 1 Ω
      E101-6 (IG) - Body ground Always 10 kΩ or higher
      E101-3 (E) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR