TELEMATICS SYSTEM SYSTEM DESCRIPTION


  1. DESCRIPTION


    1. ERA-GLONASS provides 2 services: Automatic Emergency Call and Manual Emergency Call

      If the vehicle is involved in an accident, the telematics system will make an automatic emergency call to a Public Safety Answering Point (PSAP) and transmit the vehicle location, determined by a GNSS satellite, and vehicle information. After receiving an emergency call from the vehicle, depending on the situation, a PSAP operator may immediately contact emergency services.

      A0030YRC01
      *a Emergency Call Service *b GNSS Satellite
      *c Cellular Phone Line *d Cellular Phone Base Station
      *e Mobile Network Operator (MNO) or Mobile Virtual Network Operator (MVNO) *f Public Safety Answering Point (PSAP)
      *g Public Fixed Line *h Emergency Vehicle
      *i Public safety authorities such a police or fire department *j The illustrations shown are examples only and may differ from the actual service.

  2. FUNCTION OF MAIN COMPONENTS

    Component Function

    Map Light Assembly


    • Manual (SOS) Switch

    		 Sends a switch signal to the telematics transceiver when pressed. (When a test call or manual emergency call is performed.)
    LED Indicator Light Green

    • Illuminates for 2 seconds after the ignition switch is turned to ON and the manual (SOS) switch indicator (red) has illuminated for 10 seconds.

    • Turns on when the system is operating normally.

    • Blinks during an emergency call.

    • Blinks during test mode.

    • Blinks 5 times when entering test mode (the manual (SOS) switch indicator (green) blinks at the same time).
    Red

    • Illuminates for 10 seconds after the ignition switch is turned to ON.

    • Blinks when an emergency call cannot be performed.

    • Turns off when the system is operating normally.

    • Illuminates when the mobilephone battery needs to be replaced.

    • Illuminates in diagnostic mode to indicate a DTC.

    • Blinks 5 times when entering test mode (the manual (SOS) switch indicator (red) blinks at the same time).

    Map Light Assembly


    • Telephone Microphone Assembly

    		 Sends the microphone voice signal to the telematics transceiver.
    Telephone Antenna Assembly

    • Send and receives data and voice signals used for emergency calls via a communication network.

    • Receives GPS and GLONASS radio signals and sends them to the radio receiver assembly.
    Telematics Transceiver

    • Uses the telephone antenna assembly to send and receive data and voice signals used for emergency calls via a communication network.


      • Sends the received voice signal to the vehicle speakers.

      • Receives the sent voice signal from the telephone microphone assembly.

      • Sends a mute signal to the radio and display assembly*1 or radio receiver assembly*2. (The audio system is automatically muted during an emergency call.)

      • Sends vehicle location information to the PSAP.

      • Conducts self-diagnosis every time the ignition switch is turned to ON and after an automatic emergency call or manual emergency call is made.
    Mobilephone Battery

    • When an automatic emergency call is performed, provides power to the telematics transceiver.

    • When a manual emergency call is made, is not used as the power source.
    Airbag Sensor Assembly Sends an activation signal to the telematics transceiver when the airbags deploy. (An automatic emergency call is made.)

    • *1: for Radio and Display Type

    • *2: for Radio Receiver Type

  3. MAYDAY ID OUTLINE


    1. The telematics transceiver functions as the emergency call service device to perform emergency calls.

    2. The telematics transceiver has serial numbers (IMEI, ICCID) which can be used to identify the individual device when servicing.

    3. A002ZVKC01
      *a IMEI, ICCID

      The IMEI and ICCID are printed on the label attached to the telematics transceiver.

  4. COMMUNICATION SYSTEM


    1. CAN Communication Outline


      1. The telematics system uses CAN communication between the telematics transceiver and ECUs.

  5. DIAGNOSTIC FUNCTION OUTLINE


    1. The telematics system has a diagnostic function (the result will be displayed on GTS).