NAVIGATION SYSTEM(except Sedan) Navigation Voice Circuit between Radio Receiver and Extension Module

DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on or the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the navigation ECU sends signals to the stereo component amplifier assembly via the radio and display receiver assembly.

WIRING DIAGRAM

A012JEIE14
*1 (Shielded)
*2 Radio and Display Receiver Assembly
*3 Navigation ECU

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)


    1. Disconnect the V2 radio and display receiver assembly connector.

    2. Disconnect the V1 navigation ECU connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      V2-22 (VOI+) - V1-31 (VOI+) Always Below 1 Ω
      V2-23 (VOI-) - V1-30 (VOI-) Always Below 1 Ω
      V2-24 (VSHLD) - V1-29 (VSHLD) Always Below 1 Ω
      V2-22 (VOI+) - Body ground Always 10 kΩ or higher
      V2-23 (VOI-) - Body ground Always 10 kΩ or higher
      V2-24 (VSHLD) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR