NOISE FILTER(for Sedan) INSTALLATION

PROCEDURE


  1. INSTALL RADIO SETTING CONDENSER


    1. A00306U

      Engage the claw to install a new terminal cover to the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

      • Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

      • Do not use excessive force when inserting the wire harness into the terminal cover.

      • If the terminal cover is deformed during installation, replace the terminal and terminal cover with new ones.

    2. A00310I

      Engage the 6 claws to install the 2 new terminal covers with wire harness to a new condenser.

      Note


      • Do not use excessive force when inserting the terminal cover into the condenser.

      • If a terminal cover is deformed during installation, replace the terminal, terminal covers and condenser with new ones.

    3. A0030LI

      Insert the cover as shown in the illustration and engage the claw.

    4. Engage the 3 clamps to temporarily install a new radio setting condenser with wire harness.

    5. Install the new radio setting condenser with the bolt.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

    6. Connect the connector.

  2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH

    Click here

  3. INSTALL REAR SEAT SIDE GARNISH LH

    Click here

  4. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY

    Click here

  5. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  6. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  7. INSTALL REAR SEATBACK ASSEMBLY LH

    Click here