FRONT DOOR SPEAKER(for Hatchback, Wagon) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for the RH side and LH side.

PROCEDURE


  1. REMOVE DOOR ASSIST GRIP ASSEMBLY

    Click here

  2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click here

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  6. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. A01LW4P

      Disconnect the connector.

    2. A01M06Y

      Using a drill bit with a diameter of less than 5 mm (0.197 in.), drill out the 3 rivet heads and remove the front No. 1 speaker assembly.

      Note


      • Do not touch the cone part of the speaker.

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

      • Be careful as the cut rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

  7. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (w/ Front No. 2 Speaker)


    1. A01LWLI

      Disengage the 3 claws and remove the front No. 2 speaker assembly.