STEERING HEATER SWITCH INSPECTION

PROCEDURE


  1. INSPECT STEERING HEATER SWITCH


    1. Disconnect the steering heater switch connector.

    2. A01T90AC07
      *a

      Component without harness connected

      (Steering Heater Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      6 (IG) - 3 (B) Steering heater switch is pushed Below 1 Ω
      6 (IG) - 3 (B) Steering heater switch is not pushed 10 kΩ or higher

      If the result is not as specified, replace the steering heater switch.