STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Note

w/ VSC:

Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the battery connected and the ignition switch ON.
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE

INSTALL LOWER STEERING WHEEL BOSS COVER
1. Engage the 4 pins and 2 claws to install a new lower steering wheel boss cover to the steering wheel sub-assembly.
INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)
1. Engage the 2 guides to install the 2 transmission shift switch assemblies with No. 1 switch wire to the steering wheel sub-assembly.
2. Install the 2 transmission shift switch assemblies to the steering wheel sub-assembly with the 2 screws.
  
  Torque:
  
  1.3 N*m { 13 kgf*cm, 12 in.*lbf }
INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)
1. Install the cruise control switch wire.
INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

Click here
INSTALL STEERING SHAKE DAMPER (for CVT)
1. for 1ZR-FAE:
  1. Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.
    
    Torque:
    
    2.35 N*m { 24 kgf*cm, 21 in.*lbf }
INSTALL STEERING PAD SWITCH ASSEMBLY

Click here
ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
INSPECT AND ADJUST SPIRAL CABLE SUB-ASSEMBLY (w/o VSC)

Click here
INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY (w/ VSC)

Click here
INSTALL STEERING WHEEL ASSEMBLY
1. *a Matchmark
  
  Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.
2. Install the steering wheel assembly set nut.
  
  Torque:
  
  50 N*m { 510 kgf*cm, 37 ft.*lbf }
3. Connect each connector to the spiral cable sub-assembly.
CHECK STEERING WHEEL CENTER POINT
INSTALL HORN BUTTON ASSEMBLY

Click here