REAR BRAKE FLEXIBLE HOSE(for Torsion Beam Type Suspension) REMOVAL

CAUTION / NOTICE / HINT

Note

If both RH side rear flexible hose and rear brake tube flexible hose and LH side rear flexible hose and rear brake tube flexible hose are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  3. REMOVE REAR BRAKE TUBE FLEXIBLE HOSE

    A00Y6EZC01
    *A for LH Side *B for RH Side

    1. Using a union nut wrench, disconnect the 2 brake tubes while holding the rear brake tube flexible hose with a wrench.

      Note


      • Do not bend or damage the brake tubes.

      • Do not allow any foreign matter such as dirt or dust to enter the brake tubes from the connecting parts.

    2. for LH side:


      1. Remove the clip, bolt and rear brake tube flexible hose.

    3. for RH side:


      1. Remove the 2 clips and rear brake tube flexible hose.

  4. REMOVE REAR FLEXIBLE HOSE

    Tech Tips


    • Use the same procedure for the LH side and RH side.

    • The following procedure is for the LH side.


    1. A00Y99Z

      Using a union nut wrench, disconnect the brake tube while holding the rear flexible hose with a wrench.

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.

    2. A00YBDC

      Remove the clip.

    3. A00Y75A

      Remove the union bolt, gasket and rear flexible hose.