REAR BRAKE FLEXIBLE HOSE(for Double Wishbone Type Suspension) INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the rear flexible hoses.

  • If the rear flexible hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR FLEXIBLE HOSE

    Note

    When installing the rear flexible hose, minimize twisting of the hose.


    1. Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

      Note

      Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly.

    2. Install the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

    3. Install a new clip.

      Note

      Install the clip as far as it will go.

    4. Using a union nut wrench, connect the brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

      Torque:
      15.2 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.

      • Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench.

        Click here

  2. BLEED BRAKE LINE

    Click here

  3. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }