BRAKE BOOSTER(for LHD) REMOVAL

CAUTION / NOTICE / HINT

Note

Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.

PROCEDURE


  1. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

    Click here

  2. REMOVE BRAKE ACTUATOR ASSEMBLY

    Click here

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  4. REMOVE BRAKE PEDAL RETURN SPRING

    Click here

  5. LOOSEN LOCK NUT


    1. B0042PHC01
      *1 Lock Nut
      *2 Brake Master Cylinder Push Rod Clevis

      Loosen the lock nut of the brake master cylinder push rod clevis.

  6. REMOVE PUSH ROD PIN

    Click here

  7. REMOVE HEATER PUMP ASSEMBLY (w/ Combustion Type Power Heater)

    for 1ND-TV: Click here

    for 1WW: Click here

  8. REMOVE NO. 3 HEATER BRACKET SUB-ASSEMBLY (w/ Combustion Type Power Heater)

    B0043TN

    1. Remove the nut and No. 3 heater bracket sub-assembly.

  9. DISCONNECT CHECK VALVE TO CONNECTOR TUBE HOSE


    1. B0041Z1

      Slide the clip and disconnect the check valve to connector tube hose from the brake booster assembly.

  10. REMOVE NO. 3 BRAKE TUBE CLAMP


    1. for 1ND-TV, 8NR-FTS:


      1. B0042L2

        Disengage the 2 claws to remove the brake tube heat insulator from the No. 3 brake tube clamp.

    2. B0044S7

      Disengage the clamp to remove the No. 3 brake tube clamp.

    3. for 1ND-TV, 8NR-FTS:


      1. B0042SG

        Disengage the clamp to remove the No. 3 brake tube clamp.

  11. SEPARATE FRONT NO. 1 BRAKE TUBE WAY


    1. B0041OY

      Remove the bolt and separate the front No. 1 brake tube way from the vehicle body.

  12. REMOVE BRAKE BOOSTER ASSEMBLY


    1. B004524

      w/ Stop and Start System:

      Disconnect the connector from the vacuum sensor assembly.

    2. B0043D8

      Remove the 4 nuts and push the brake booster assembly toward the engine compartment.

      Note

      Do not apply excessive force to the brake lines.

    3. Remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.

    4. Remove the brake booster assembly from the vehicle body.

      Note

      Do not apply excessive force to the brake lines or refrigerant lines.

  13. REMOVE BRAKE BOOSTER GASKET