BRAKE MASTER CYLINDER(for LHD) REASSEMBLY

PROCEDURE


  1. INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER

  2. INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

  3. INSTALL MASTER CYLINDER RESERVOIR GROMMET


    1. Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new master cylinder reservoir grommets.

    2. Install the 2 master cylinder reservoir grommets to the brake master cylinder reservoir assembly.

  4. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY


    1. Mount the brake master cylinder body in a vise.

      Note

      Place aluminum plates on the vise to prevent damage to the brake master cylinder body.

    2. for Type A Brake Master Cylinder Sub-assembly:


      1. Engage the claw to install the wire harness clamp bracket.

      2. Install the brake master cylinder reservoir assembly to the brake master cylinder body.

        Note

        Do not drop the brake master cylinder reservoir assembly.

      3. Using an E7 "TORX" socket wrench, install the brake master cylinder reservoir assembly to the brake master cylinder body with the "TORX" screw.

        Torque:
        4.0 N*m  { 41 kgf*cm, 35 in.*lbf }

    3. for Type B Brake Master Cylinder Sub-assembly:


      1. A012KP0

        Using a 5 mm pin punch and a hammer, tap in the brake master cylinder ring pin to secure the brake master cylinder reservoir assembly.

    4. Remove the brake master cylinder sub-assembly from the vise.