BRAKE PEDAL(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY


    1. Install the nut to the brake pedal support assembly.

    2. A01TBTMN01

      Install the brake pedal support assembly with the 4 nuts.

      Torque:
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }

      Note

      Tighten the 4 nuts in the order shown in the illustration.

    3. A01TD1GN01

      Engage the clamp (a) to install the wire harness to the brake pedal support assembly.

    4. for Manual Transaxle:

      Engage the clamp (b) to install the wire harness to the brake pedal support assembly.

    5. Install the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.

      Torque:
      23.6 N*m  { 241 kgf*cm, 17 ft.*lbf }

  2. INSTALL PUSH ROD PIN


    1. A01TD0QC01
      A01TC4W Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support assembly.

    2. A01T9RS

      Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin as shown in the illustration and install a new clip.

      Note

      Install the push rod pin in the correct direction.

  3. INSTALL BRAKE PEDAL RETURN SPRING


    1. Install the brake pedal return spring to the brake pedal support assembly and push rod pin.

  4. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

    Click here

  5. INSTALL STOP LIGHT SWITCH ASSEMBLY

    Click here

  6. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Tech Tips

    Use the same procedure as for LHD.

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  7. INSTALL COMBINATION METER ASSEMBLY

    Tech Tips

    Use the same procedure as for LHD.

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  8. INSPECT AND ADJUST BRAKE PEDAL

    Click here