REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

   
   

   1. Install the rear axle hub and bearing assembly.

      for Torsion Beam Type Suspension: Click here

      for Double Wishbone Type Suspension: Click here

      Tech Tips

      
      

      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor is malfunctioning, replace the rear axle hub and bearing assembly.

      • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

2. INSPECT REAR AXLE HUB BEARING LOOSENESS

   for Torsion Beam Type Suspension: Click here

   for Double Wishbone Type Suspension: Click here

3. INSPECT REAR AXLE HUB RUNOUT

   for Torsion Beam Type Suspension: Click here

   for Double Wishbone Type Suspension: Click here

4. CONNECT SKID CONTROL SENSOR WIRE

   
   

   1. Connect the connector to the rear speed sensor.

5. INSTALL REAR DISC

   Click here

6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

   for Torsion Beam Type Suspension: Click here

   for Double Wishbone Type Suspension: Click here

7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

   for Torsion Beam Type Suspension: Click here

   for Double Wishbone Type Suspension: Click here

8. INSTALL PARKING BRAKE LEVER PROTECTOR (for Double Wishbone Type Suspension)

   Click here

9. ADJUST PARKING BRAKE

   Click here

10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

    for Sedan: Click here

    for Hatchback, Wagon: Click here

11. INSTALL REAR WHEEL

    Torque:

    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

13. CHECK FOR SPEED SENSOR SIGNAL

    w/o VSC: Click here

    w/ VSC: Click here