BRAKE PEDAL(for LHD) INSTALLATION

PROCEDURE


  1. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY


    1. Install the nut to the brake pedal support assembly.

    2. A01T8G5N01

      Install the brake pedal support assembly with the 4 nuts.

      Torque:
      12.7 N*m  { 130 kgf*cm, 9 ft.*lbf }

      Note

      Tighten the 4 nuts in the order shown in the illustration.

    3. Engage the 2 clamps to install the wire harness to the brake pedal support assembly.

    4. Install the brake pedal support assembly to the instrument panel reinforcement assembly with the bolt.

      Torque:
      23.6 N*m  { 241 kgf*cm, 17 ft.*lbf }
    5. A01T9M6

      Connect the connector to the main body ECU.

    6. Engage the claw to install the wire harness protector to the instrument panel junction block assembly.

  2. INSTALL PUSH ROD PIN


    1. A01TCI3C01
      A01TC4W Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support assembly.

    2. A01T99J

      Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin as shown in the illustration and install a new clip.

      Note

      Install the push rod pin in the correct direction.

  3. INSTALL BRAKE PEDAL RETURN SPRING


    1. Install the brake pedal return spring to the brake pedal support assembly and push rod pin.

  4. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

    Click here

  5. INSTALL STOP LIGHT SWITCH ASSEMBLY

    Click here

  6. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Instrument Panel Under Cover)

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  7. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  8. INSTALL COMBINATION METER ASSEMBLY

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  9. INSPECT AND ADJUST BRAKE PEDAL

    Click here