VEHICLE STABILITY CONTROL SYSTEM DIAGNOSIS SYSTEM


  1. DESCRIPTION

    When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the skid control ECU (brake actuator assembly).

    The skid control ECU (brake actuator assembly) records DTCs when it detects a malfunction in itself or in its circuits.

    To check for DTCs, connect the GTS to the DLC3 on the vehicle. The GTS can be used to clear the DTCs, activate various actuators, and check the Freeze Frame Data and Data List.


    1. Check the battery voltage.

      If the voltage is below 11 V, recharge the battery before proceeding to the next step.

    2. Check the DLC3.

      Click here

    3. DIAGNOSIS


      1. If the skid control ECU (brake actuator assembly) detects a malfunction, the ABS warning, brake warning, and/or slip indicator lights will come on in order to warn the driver.

      2. DTCs are simultaneously stored in memory. The DTCs can be read by connecting SST between terminals TC and CG of the DLC3 and observing the blinking pattern of the ABS warning and slip indicator lights, or by connecting the GTS.

        Click here

      3. This system has a Test Mode (signal check) function.

        The DTCs can be read by connecting SST between terminals TS and CG of the DLC3 and observing the blinking pattern of the ABS warning and slip indicator lights, or by connecting the GTS.

        Click here

    4. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK


      1. Release the parking brake.

        Note

        Before releasing the parking brake, move the shift lever to P for safety (for multi drive / CVT), move the shift lever to N for safety (for multi-mode manual transaxle) or use wheel chocks to secure the vehicle (for manual transaxle).

        Tech Tips

        When the parking brake is applied or the brake fluid level is low, the brake warning light comes on.

      2. When the ignition switch is turned to ON, check that the ABS warning, brake warning, slip indicator, TRC OFF indicator (except Multi-information Display (Color Type)) and VSC OFF indicator lights all come on for approximately 3 seconds.

        Tech Tips


        • If the warning light and indicator light check result is not normal, proceed to troubleshooting for the ABS warning, brake warning, TRC OFF indicator (w/o Multi-information Display), VSC OFF indicator and slip indicator light circuits.

        • If any of the indicators remains on or does not come on, proceed to troubleshooting for the light circuits listed below.

      5. Trouble Area See Procedure
      ABS warning light circuit (Remains on)

      Click here

      ABS warning light circuit (Does not come on)

      Click here

      Brake warning light circuit (Remains on)

      Click here

      Brake warning light circuit (Does not come on)

      Click here

      TRC OFF indicator light circuit (Remains on)

      Click here

      TRC OFF indicator light circuit (Does not come on)

      Click here

      VSC OFF indicator light circuit (Reminds on)

      Click here

      VSC OFF indicator light circuit (Does not come on)

      Click here

      Slip indicator light circuit (Remains on)

      Click here

      Slip indicator light circuit (Does not come on)

      Click here