REAR COIL SPRING(for Double Wishbone Type Suspension) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR UPPER COIL SPRING INSULATOR


    1. A01TCDEC05
      *a 10 mm or less

      Install the rear upper coil spring insulator to the rear coil spring.

      Note

      Install the rear upper coil spring insulator so that the dimension between the stopper and upper end of the rear coil spring is 10 mm (0.394 in.) or less.

  2. INSTALL REAR LOWER COIL SPRING INSULATOR


    1. Install the rear lower coil spring insulator to the rear No. 2 suspension arm assembly.

  3. INSTALL REAR COIL SPRING


    1. A01TB3DC01
      *a Identification Mark
      *b 30° or less
      *c Lower End of Rear Coil Spring

      Set the rear coil spring to the rear No. 2 suspension arm assembly.

      Note


      • Set the rear coil spring so that the identification marks are positioned as shown in the illustration.

      • Set the rear coil spring so that its lower end is within the range shown in the illustration.

    2. A01T9T2C02
      *a Wooden Block
      *b Jack
      A01TCE3 Bolt (A)
      A01TBGJ Bolt (B)

      Using a jack and wooden block, slowly jack up the rear No. 2 suspension arm assembly.

      CAUTION:

      Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

      Note


      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

      • Make sure to perform this operation with the vehicle kept as low as possible.

    3. Temporarily install the bolt (A) and nut.

      Note


      • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

      • Insert the bolt with the threaded end facing the front of the vehicle.

    4. Install the bolt (B) and nut.

      Torque:
      90 N*m  { 918 kgf*cm, 66 ft.*lbf }

      Note


      • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

      • Insert the bolt with the threaded end facing the front of the vehicle.

  4. INSTALL REAR STABILIZER LINK ASSEMBLY

    Click here

  5. INSTALL REAR SUSPENSION MEMBER BRACE

    Click here

  6. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (w/ Height Control Sensor)

    Click here

  7. STABILIZE SUSPENSION

    Click here

  8. FULLY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY

    Click here

  9. INSTALL REAR FLOOR SIDE MEMBER COVER LH (for LH Side)

    Click here

  10. INSTALL REAR FLOOR SIDE MEMBER COVER RH (for RH Side)

    Click here

  11. INSTALL REAR SUSPENSION ARM COVER

    Click here

  12. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here