FRONT AXLE HUB REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE FRONT WHEEL

2. REMOVE FRONT AXLE SHAFT NUT

   for 1AD-FTV: Click here

   for 1ND-TV: Click here

   for 1NR-FE: Click here

   for 1ZR-FAE: Click here

3. SEPARATE FRONT SPEED SENSOR

   
   

   1. 

      Remove the bolt, disengage the clamp and separate the front speed sensor wire and front flexible hose from the front shock absorber assembly.

      Note

      Be sure to separate the front speed sensor from the front shock absorber assembly completely.

   2. 

      Remove the bolt and separate the front speed sensor from the steering knuckle.

      Note

      
      

      • Prevent foreign matter from contacting the sensor tip.

      • Be careful not to damage the front speed sensor.

      • Clean the front speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.

4. SEPARATE FRONT FLEXIBLE HOSE

   
   

   1. 

      Remove the bolt and separate the front flexible hose from the steering knuckle.

5. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

   Click here

6. REMOVE FRONT DISC

   Click here

7. SEPARATE TIE ROD END SUB-ASSEMBLY

   Click here

8. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

   
   

   1. 

      Remove the bolt and 2 nuts, and separate the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.

      Note

      Do not damage the boot of the ball joint.

9. SEPARATE FRONT DRIVE SHAFT ASSEMBLY

   
   
   1. 

      *a

      Matchmark

      Put matchmarks on the front drive shaft assembly and front axle hub sub-assembly.

   2. Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.

      Note

      Be careful not to damage the drive shaft boot.

      Tech Tips

      If it is difficult to separate the front drive shaft assembly from the front axle assembly, tap the end of the front drive shaft assembly using a brass bar and a hammer.

10. REMOVE FRONT AXLE ASSEMBLY

    
    

    1. 

       Remove the 2 bolts, 2 nuts and front axle assembly from the front shock absorber assembly.

       Note

       
       

       • When removing the nuts, keep the bolts from rotating.

       • Be careful not to damage the drive shaft boot.

11. REMOVE FRONT AXLE HUB SUB-ASSEMBLY

    
    

    1. Secure the front axle assembly between aluminum plates in a vise.

       Note

       Do not overtighten the vise.

    2. 

       Remove the 4 bolts, front axle hub sub-assembly and front disc brake dust cover from the steering knuckle.

       Note

       
       

       • Do not drop the front axle hub sub-assembly.

       • Do not allow the magnet rotor side to become damaged or contact foreign matter.