FRONT DRIVE SHAFT ASSEMBLY(for 1ZR-FE, 2ZR-FE) INSPECTION

PROCEDURE


  1. INSPECT FRONT DRIVE SHAFT ASSEMBLY


    1. A01TCPI

      Check that there is no excessive play in the radial direction of the outboard joint.

    2. Check that the inboard joint slides smoothly in the thrust direction.

    3. Check that there is no excessive play in the radial direction of the inboard joint.

    4. Check the boots for damage.

    5. A01TD54N23

      Check whether each drive shaft dimension (A) is within specification.

      Note

      Keep the drive shaft assembly level during inspection.

      Dimension (A)
      for LH Side 589.5 mm (1.93 ft.)
      for RH Side 875.25 mm (2.87 ft.)