FRONT DRIVE SHAFT ASSEMBLY(for 1NR-FE) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEELS

  2. REMOVE REAR ENGINE UNDER COVER LH

  3. REMOVE REAR ENGINE UNDER COVER RH

  4. DRAIN MANUAL TRANSAXLE OIL

    Click here

  5. REMOVE FRONT AXLE SHAFT NUT


    1. A00Y5HPN05

      Using SST and a hammer, release the staked part of the front axle shaft nut.

      SST
      09930-00010

      Note

      Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.

    2. While applying the brakes, remove the front axle shaft nut.

  6. SEPARATE FRONT SPEED SENSOR

    Click here

  7. SEPARATE FRONT FLEXIBLE HOSE

    Click here

  8. SEPARATE TIE ROD END SUB-ASSEMBLY

    Click here

  9. SEPARATE FRONT STABILIZER LINK ASSEMBLY

    Click here

  10. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

    Click here

  11. SEPARATE FRONT DRIVE SHAFT ASSEMBLY

    Click here

  12. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH


    1. A00Y5WTN08

      Using SST, remove the front drive shaft assembly LH.

      SST
      09520-01010
      09520-24010   ( 09520-32040 )

      Note


      • Do not damage the transmission case oil seal.

      • Do not damage the front axle inboard joint boot.

      • Do not drop the front drive shaft assembly LH.

  13. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  14. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH


    1. A00Y9F9

      Using a screwdriver, remove the front drive shaft hole snap ring.