FRONT DRIVE SHAFT ASSEMBLY(for 1NR-FE) COMPONENTS
ILLUSTRATION
| *1 | REAR ENGINE UNDER COVER LH | *2 | REAR ENGINE UNDER COVER RH |
ILLUSTRATION
| *1 | FRONT AXLE SHAFT NUT | *2 | FRONT DRIVE SHAFT ASSEMBLY LH |
| *3 | FRONT FLEXIBLE HOSE | *4 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY |
| *5 | FRONT SPEED SENSOR | *6 | FRONT STABILIZER LINK ASSEMBLY |
| *7 | TIE ROD END SUB-ASSEMBLY | *8 | FRONT AXLE ASSEMBLY |
| *9 | COTTER PIN | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Do not apply lubricants | - | - |
ILLUSTRATION
| *A | w/ Drive Shaft Damper | *B | w/o Drive Shaft Damper |
| *1 | FRONT DRIVE SHAFT ASSEMBLY LH | *2 | FRONT DRIVE SHAFT ASSEMBLY RH |
| *3 | FRONT DRIVE SHAFT HOLE SNAP RING | *4 | TRANSMISSION CASE OIL SEAL |
| *5 | TRANSAXLE CASE OIL SEAL | - | - |
| ● | Non-reusable part |  |
Gear oil |
 |
MP grease | - | - |
ILLUSTRATION
| *A | for LH Side | - | - |
| *1 | FRONT AXLE INBOARD JOINT BOOT | *2 | FRONT AXLE INBOARD JOINT BOOT CLAMP |
| *3 | FRONT AXLE OUTBOARD JOINT BOOT | *4 | FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
| *5 | FRONT DRIVE INBOARD JOINT ASSEMBLY | *6 | FRONT DRIVE SHAFT DUST COVER |
| *7 | FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP | *8 | FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP |
| *9 | SHAFT SNAP RING | *10 | TRIPOD JOINT |
| *11 | FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *A | for RH Side | *B | w/ Drive Shaft Damper |
| *1 | FRONT AXLE INBOARD JOINT BOOT | *2 | FRONT AXLE INBOARD JOINT BOOT CLAMP |
| *3 | FRONT AXLE OUTBOARD JOINT BOOT | *4 | FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
| *5 | FRONT DRIVE INBOARD JOINT ASSEMBLY | *6 | FRONT DRIVE SHAFT DAMPER RH |
| *7 | FRONT DRIVE SHAFT DUST COVER | *8 | FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP |
| *9 | FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP | *10 | SHAFT SNAP RING |
| *11 | TRIPOD JOINT | *12 | FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY |
| *13 | FRONT DRIVE SHAFT DAMPER CLAMP | - | - |
| ● | Non-reusable part | - | - |