FRONT DRIVE SHAFT ASSEMBLY(for 1ND-TV) INSTALLATION

PROCEDURE


  1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING


    1. Install a new front drive shaft hole snap ring.

      Note

      Face the end gap of the front drive shaft hole snap ring downward.

  2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH


    1. Coat the splines of the front drive inboard joint assembly with gear oil.

    2. Coat the lip of the transmission case oil seal with MP grease.

    3. B0044KL

      Align the inboard joint splines, and using a brass bar and a hammer, install the front drive shaft assembly LH.

      Note


      • Face the end gap of the front drive shaft hole snap ring downward.

      • Do not damage the transmission case oil seal.

      • Do not damage the front axle inboard joint boot.

      • Make sure to center the front drive shaft assembly LH during installation to prevent damage to the front drive shaft hole snap ring.

      Tech Tips

      Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.

    4. B0043MEC01
      *a Matchmark

      Align the matchmarks and install the front drive shaft assembly LH to the front axle hub sub-assembly.

      Note

      Be careful not to damage the front axle outboard joint boot.

  3. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  4. CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

    Click here

  5. INSTALL FRONT STABILIZER LINK ASSEMBLY

    Click here

  6. CONNECT TIE ROD END SUB-ASSEMBLY

    Click here

  7. INSTALL FRONT FLEXIBLE HOSE

    Click here

  8. INSTALL FRONT SPEED SENSOR

    Click here

  9. INSTALL FRONT AXLE SHAFT NUT


    1. Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using non-residue solvent.

      Note


      • Be sure to perform this work even when using a new drive shaft.

      • Keep the threaded parts free of oil and foreign matter.

    2. B00437J

      Using a 30 mm socket wrench, install the front axle shaft nut.

      Torque:
      216 N*m  { 2203 kgf*cm, 159 ft.*lbf }

      Tech Tips

      Keep depressing the brake pedal to prevent the drive shaft from rotating.

    3. Using a chisel and a hammer, stake the front axle shaft nut.

  10. ADD MANUAL TRANSAXLE OIL

    for Manual Transaxle: Click here

    for Multi-Mode Manual Transaxle: Click here

  11. INSPECT FOR OIL LEAK

  12. INSTALL REAR ENGINE UNDER COVER LH

    Click here

  13. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  14. INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here

  15. INSTALL FRONT WHEELS

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  16. ADJUST FRONT WHEEL ALIGNMENT

    Click here

  17. CHECK FOR SPEED SENSOR SIGNAL

    w/o VSC: Click here

    w/ VSC: Click here