SHIFT PADDLE SWITCH INSPECTION

PROCEDURE


  1. INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. A00Y7VAC11
      *a

      Component without harness connected

      (Transmission Shift Switch Assembly LH)
      *b

      Component without harness connected

      (Transmission Shift Switch Assembly RH)

      Measure the resistance between each terminal when the transmission shift switch assembly is moved to each position.

      Standard Resistance
      Transmission Shift Switch Assembly LH
      Tester Connection Condition Specified Condition
      2 (SFTD) - 3 (ECC) Pull "-" continuously (Downshift) Below 3 Ω
      Release 10 kΩ or higher
      2 (SFTD) - 4 (ECC1) Pull "-" continuously (Downshift) Below 3 Ω
      Release 10 kΩ or higher
      Transmission Shift Switch Assembly RH
      Tester Connection Condition Specified Condition
      3 (SFTU) - 2 (ECC1) Pull "+" continuously (Upshift) Below 3 Ω
      Release 10 kΩ or higher

      If the resistance is not as specified, replace the transmission shift switch assembly.