MULTI-MODE MANUAL TRANSAXLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Note

When the multi-mode manual transaxle assembly is removed, be sure to use a new clutch release with bearing cylinder assembly and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder assembly to return to its original position. Dust from the moving section may damage the seal of the clutch release with bearing cylinder assembly, possibly causing clutch fluid leaks.

PROCEDURE


  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    Click here

  2. REMOVE FRONT ENGINE MOUNTING INSULATOR

    Click here

  3. REMOVE REAR ENGINE MOUNTING INSULATOR

    Click here

  4. REMOVE NO. 1 AIR TUBE


    1. A01M1W6C01
      *a Hose Clamp

      Disconnect the wire harness clamp.

    2. Remove the 4 bolts.

    3. Loosen the hose clamp and remove the No. 1 air tube.

  5. REMOVE STARTER ASSEMBLY

    Click here

  6. DISCONNECT WIRE HARNESS


    1. A01M1MC

      Disconnect the 2 connectors from the select stroke sensor and park/neutral position switch assembly.

    2. Disconnect the 3 clamps and remove the wire harness.

    3. A01M079

      Disconnect the 2 clamps.

    4. Remove the nut and bolt, and disconnect the wire harness from the multi-mode manual transaxle assembly.

  7. REMOVE MULTI-MODE MANUAL TRANSAXLE ASSEMBLY


    1. A01LWM6

      Remove the 8 bolts and multi-mode manual transaxle assembly.

  8. REMOVE ENGINE MOUNTING BRACKET LH


    1. A01LW91C01
      *A Type A
      *B Type B

      Remove the 4 bolts and engine mounting bracket LH.

  9. REMOVE FRONT ENGINE MOUNTING BRACKET


    1. A01LXVO

      Remove the 4 bolts and front engine mounting bracket.

  10. REMOVE REAR ENGINE MOUNTING BRACKET


    1. A01LZPM

      Remove the 4 bolts and rear engine mounting bracket.

  11. REMOVE CLUTCH ACTUATOR ASSEMBLY

    Note


    • If the clutch actuator assembly is removed from the multi-mode manual transaxle assembly, perform Learning of Multi-mode Manual Transaxle System.

    • When Learning of Multi-mode Manual Transaxle System is performed, the clutch disc assembly and clutch cover assembly have to be replaced as a set.

    Click here

  12. REMOVE NO. 1 CLUTCH ACTUATOR BRACKET


    1. A01LXM1

      Remove the 4 bolts and No. 1 clutch actuator bracket from the multi-made manual transaxle assembly.

  13. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

    Click here

  14. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

    Click here

  15. REMOVE CLUTCH RELEASE CYLINDER TO BLEEDER TUBE

    Click here

  16. REMOVE WIRE HARNESS CLAMP BRACKET


    1. A01LY53

      Remove the 3 bolts and 3 wire harness clamp brackets.

  17. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY


    1. A01M3IN

      Remove the bolt and speedometer driven hole cover sub-assembly from the transaxle case.

    2. Remove the O-ring from the speedometer driven hole cover sub-assembly.