SHIFT AND SELECT ACTUATOR REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  2. REMOVE BATTERY

    Click here

  3. REMOVE FUEL FILTER ASSEMBLY

    Click here

  4. DISCONNECT ENGINE WIRE

    Click here

  5. REMOVE FUEL FILTER SUPPORT

    Click here

  6. REMOVE AIR CLEANER BRACKET

    Click here

  7. REMOVE NO. 1 AIR TUBE


    1. A01TCVMC01
      *a Hose Clamp

      Disconnect the wire harness clamp.

    2. Remove the 4 bolts.

    3. Loosen the 2 hose clamps and remove the No. 1 air tube.

  8. DISCONNECT WIRE HARNESS


    1. A01T99Q

      Disconnect the 5 wire harness clamps.

    2. A01TDM4

      Disconnect the 6 connectors.

    3. A01TCF0

      Disconnect the select stroke sensor connector.

    4. Disconnect the 3 wire harness clamps.

  9. REMOVE SHIFT AND SELECT ACTUATOR ASSEMBLY


    1. A01TCB1

      Remove the bolt and wire harness clamp bracket from the shift and select actuator.

    2. A01TCE9

      Remove the bolt and wire harness clamp bracket from the shift and select actuator.

    3. A01T9W1

      Remove the 6 bolts, wire harness clamp bracket and shift and select actuator from the transaxle case.

    4. A01TDBY

      Remove the 2 ring pins from the shift and select actuator.

    5. A01TAHD

      Remove the bolt and breather protector from the shift and select actuator.

    6. A01T8XI

      Remove the breather plug cap from the shift and select actuator.