SHIFT PADDLE SWITCH INSPECTION

PROCEDURE


  1. INSPECT SHIFT PADDLE SWITCH


    1. A00Y7VAC17
      *a

      Component without harness connected

      (Shift Paddle Switch LH)
      *b

      Component without harness connected

      (Shift Paddle Switch RH)

      Measure the resistance according to the values in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 (SFTU) - 2 (ECC1) "+" continuously pulled Below 2.5 Ω
      Released 1 MΩ or higher
      2 (SFTD) - 3 (ECC) "-" continuously pulled Below 2.5 Ω
      Released 1 MΩ or higher
      2 (SFTD) - 4 (ECC1) "-" continuously pulled Below 2.5 Ω
      Released 1 MΩ or higher

      If the resistance is not as specified, replace the shift paddle switch.