MULTI-MODE MANUAL TRANSAXLE SYSTEM, Diagnostic DTC:P0562

DTC Code DTC Name
P0562 System Voltage

DESCRIPTION

The battery supplies electricity to the TCM even when the ignition switch is off. This power allows the TCM to store data such as the learned value of actuators, DTC history and freeze frame data. If the battery voltage falls below a minimum level, these memories are cleared and the TCM determines that there is a malfunction in the power supply circuit. If an open or short circuit occurs in the +B circuit while the ignition switch is ON, the TCM stops operating immediately.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate Memory
P0562 System Voltage

+B terminal voltage 7.0 V or less for 0.5 seconds or more

(1-trip detection logic)

  • Wire harness or connector

  • TCM

 Comes on Comes on DTC stored

WIRING DIAGRAM

A01TABZE01
*a ECU-B NO. 2
*b FL MAIN
*c Battery

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (TCM - BATTERY, BODY GROUND)


    1. A01TBDQC02
      *a

      Front view of wire harness connector

      (to TCM)

      Disconnect the TCM connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E104-6 (GND) - Body ground Always Below 1 Ω
      A104-1 (PGND) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      E104-1 (+B) - E104-6 (GND) Always 11 to 14 V
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. REPLACE TCM


    1. Replace the TCM.

      for LHD: Click here

      for RHD: Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. PERFORM INITIALIZATION


    1. Perform the initialization and learning procedure.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    END