MANUAL TRANSAXLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Note

When the manual transaxle assembly is removed, be sure to use a new clutch release with bearing cylinder assembly and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder assembly to return to its original position. Dust from the moving section may damage the seal of the clutch release with bearing cylinder assembly, possibly causing clutch fluid leaks.

PROCEDURE


  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 1ZR-FAE)

    Click here

  2. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE (for 1ZR-FE)

    Click here

  3. REMOVE FRONT ENGINE MOUNTING INSULATOR (for 1ZR-FAE)

    Click here

  4. REMOVE FRONT ENGINE MOUNTING INSULATOR (for 1ZR-FE)

    Click here

  5. REMOVE REAR ENGINE MOUNTING INSULATOR (for 1ZR-FAE)

    Click here

  6. REMOVE REAR ENGINE MOUNTING INSULATOR (for 1ZR-FE)

    Click here

  7. REMOVE STARTER ASSEMBLY (for 1ZR-FAE)

    Click here

  8. REMOVE STARTER ASSEMBLY (for 1ZR-FE)

    Click here

  9. DISCONNECT WIRE HARNESS


    1. B00433N

      Disconnect the clamp from the manual transaxle assembly.

    2. Disconnect the back-up light switch assembly connector.

  10. REMOVE MANUAL TRANSAXLE ASSEMBLY


    1. B0042F2

      Remove the 7 bolts and manual transaxle assembly from the engine assembly.

  11. REMOVE FRONT ENGINE MOUNTING BRACKET


    1. B0043G2

      Remove the 4 bolts and front engine mounting bracket from the manual transaxle assembly.

  12. REMOVE ENGINE MOUNTING BRACKET LH


    1. B00420SC01
      *A Type A
      *B Type B

      Remove the 4 bolts and engine mounting bracket LH from the manual transaxle assembly.

  13. REMOVE REAR ENGINE MOUNTING BRACKET


    1. B0042WU

      Remove the 4 bolts and rear engine mounting bracket from the manual transaxle assembly.

  14. REMOVE BLEEDER CLUTCH RELEASE TUBE

    Click here

  15. REMOVE CLUTCH FLEXIBLE HOSE BRACKET


    1. B00446J

      Remove the bolt and clutch flexible hose bracket from the manual transaxle assembly.

  16. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

    Click here

  17. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

    Click here

  18. REMOVE CLUTCH RELEASE CYLINDER TO BLEEDER TUBE

    Click here

  19. REMOVE WIRE HARNESS CLAMP BRACKET


    1. B0043CM

      Remove the bolt and wire harness clamp bracket from the manual transaxle assembly.

  20. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY


    1. B0044PR

      Remove the bolt and speedometer driven hole cover sub-assembly from the manual transaxle assembly.

    2. Remove the O-ring from the speedometer driven hole cover sub-assembly.