MANUAL TRANSAXLE ASSEMBLY COMPONENTS
ILLUSTRATION
| *A | Type A | *B | Type B |
| *C | w/ Stop and Start System | *D | w/o Stop and Start System |
| *1 | ENGINE ASSEMBLY WITH TRANSAXLE | *2 | FRONT ENGINE MOUNTING INSULATOR |
| *3 | REAR ENGINE MOUNTING INSULATOR | *4 | SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY |
| *5 | O-RING | *6 | WIRE HARNESS |
| *7 | WATER HOSE | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Gear oil | - | - |
ILLUSTRATION
| *1 | DRIVE SHAFT HEAT INSULATOR SUB-ASSEMBLY | *2 | MANIFOLD SUPPORT BRACKET |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | w/ Stop and Start System | *B | w/o Stop and Start System |
| *C | Type A | *D | Type B |
| *1 | CLUTCH FLEXIBLE HOSE BRACKET | *2 | CLUTCH RELEASE BLEEDER SUB-ASSEMBLY |
| *3 | BLEEDER CLUTCH RELEASE TUBE | *4 | CLUTCH RELEASE CYLINDER TO BLEEDER TUBE |
| *5 | CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY | *6 | ENGINE MOUNTING BRACKET LH |
| *7 | FRONT ENGINE MOUNTING BRACKET | *8 | MANUAL TRANSAXLE ASSEMBLY |
| *9 | REAR ENGINE MOUNTING BRACKET | *10 | STARTER ASSEMBLY |
| *11 | NO. 1 HEATER BRACKET SUB-ASSEMBLY | *12 | CLUTCH TUBE BOOT |
| *13 | FLYWHEEL HOUSING SIDE COVER | *14 | TERMINAL CAP PROTECTOR |
| *15 | TERMINAL CAP | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with a union nut wrench |
| ● | Non-reusable part | |
Clutch spline grease |
 |
Adhesive 1324 | ★ | Precoated part |
| *T1 | for Flange Bolt: 37 (377, 27) for Bolt with Washer: 33 (337, 24) |
- | - |