CLUTCH ACTUATOR(for EC65A) REMOVAL

CAUTION / NOTICE / HINT

Note


  • If the clutch actuator assembly is removed from the multi-mode manual transaxle assembly, perform Learning of Multi-mode Manual Transaxle System.

  • When Learning of Multi-mode Manual Transaxle System is performed, the clutch disc assembly and clutch cover assembly have to be replaced as a set.

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    Click here

  2. REMOVE NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here

  3. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. REMOVE BATTERY

    Click here

  7. REMOVE NO. 2 BATTERY CARRIER

    Click here

  8. REMOVE CLUTCH ACTUATOR ASSEMBLY


    1. A01M18IC01
      *a Clutch Stroke Sensor Connector
      *b Clutch Motor Assembly Connector

      Disconnect the clutch stroke sensor connector.

    2. Disconnect the clutch motor assembly connector.

    3. Remove the bolt and disconnect the wire harness from the clutch actuator assembly.

      Note

      Do not forcibly pull the clutch stroke sensor connector as this may damage the wire harness.

    4. A01LYX0

      Using a 10 mm union nut wrench, remove the bleeder clutch release tube.

    5. A01LZGN

      Remove the 3 bolts and clutch actuator assembly from the No. 1 clutch actuator bracket.

      Note

      If a component has been dropped or subjected to a strong impact, replace it.