CLUTCH RELEASE CYLINDER(for EA66) INSTALLATION

PROCEDURE

1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY

   
   

   1. Install the clutch release cylinder assembly and clutch line bracket to the manual transaxle assembly with the 2 bolts.

      Torque:

      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

2. CONNECT CLUTCH LINE

   
   

   1. Install the clutch line clamp to the clutch release cylinder assembly with the bolt.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   2. Using a 10 mm union nut wrench, connect the clutch line.

      Torque:

      15.2 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note

      
      

      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a union nut wrench.

        Click here

3. FILL RESERVOIR WITH BRAKE FLUID

   Click here

4. BLEED CLUTCH LINE

   Click here

5. INSPECT BRAKE FLUID LEVEL IN RESERVOIR

   Click here

6. INSPECT FOR FLUID LEAK

   Tech Tips

   Check for leakage in the clutch system.

7. INSTALL BATTERY CARRIER BRACKET SUB-ASSEMBLY

   Click here

8. INSTALL BATTERY

   Click here

9. INSTALL NO. 1 ENGINE UNDER COVER

   Click here

10. INSTALL NO. 2 RADIATOR AIR GUIDE

    Click here