CLUTCH RELEASE CYLINDER(for EA66) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 ENGINE COVER

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. DRAIN ENGINE COOLANT

    Click here

  6. REMOVE BATTERY

    Click here

  7. REMOVE BATTERY CARRIER

    Click here

  8. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE ASSEMBLY

    Click here

  9. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  11. DISCONNECT ENGINE WIRE

    Click here

  12. REMOVE NO. 4 WATER BY-PASS HOSE

    Click here

  13. DISCONNECT COMPRESSOR OUTLET ELBOW

    Click here

  14. DISCONNECT NO. 2 AIR HOSE

    Click here

  15. REMOVE NO. 1 AIR TUBE ASSEMBLY

    Click here

  16. DISCONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE


    1. B0042MA

      Using a 10 mm union nut wrench, disconnect the clutch release cylinder to flexible hose tube from the clutch release cylinder assembly.

      Tech Tips

      Use a container to collect the fluid.

  17. REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY


    1. B0042VN

      Remove the 2 bolts, clutch release cylinder assembly from the manual transaxle assembly.