OIL PUMP ASSEMBLY(for 8NR-FTS) REMOVAL

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  2. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click here

  3. REMOVE FRONT ENGINE MOUNTING INSULATOR


    1. B00451E

      Remove the bolt and nut, and separate the front engine mounting insulator from the front engine mounting bracket.

    2. B00434R

      Remove the 2 bolts and front engine mounting insulator from the front crossmember sub-assembly.

  4. REMOVE FRONT ENGINE MOUNTING BRACKET

    Click here

  5. REMOVE OIL PUMP WITH MOTOR ASSEMBLY


    1. B0044YY

      Disconnect the oil pump with motor assembly connector.

    2. Remove the bolt and disconnect the wire harness from the oil pump with motor assembly.

    3. B0043VN

      Remove the 3 bolts and oil pump with motor assembly from the continuously variable transaxle assembly.

      Note

      The O-ring of the oil pump with motor assembly is not available as a supply part. As the O-ring is a non-reusable part, if the oil pump with motor assembly is removed, the oil pump with motor assembly must be replaced with a new one.